mlasham wrote:
I understand that, but that was not my question.
If I map a vdrive to mdv3 thats fine.
But the s/w on the image wants to be mdv1
If I setup a bank with mdv1-6 assigned to vdrives for the images, most just want to be mdv1.
I think a menu program is requrired which gives a list of images, and loads which ever is selected to mdv1.
failing that I have to edit every image to change the BASIC code to load from mdv1
hope that makes sense
You can use vMap mode 3 to 9 - so mdv1_ will be mapped to a vDrive
Load vDrive Toolkit - I copied it from vDrive to a directory on my SD-drive and I load it at start-up, in boot. This will extend SuperBasic with all commands for vDrive
Then to load an image 'MyImg' to vDrive 1 simply use command LD 1, 'MyIMG'
Of course, you can write a menu program to select banks and load images to specific vDrive mdv_,
(I don't usually use banks - I just load images using LD comand; CD 'dir' to change directory; LS to list the images in the directory etc. )