Page 1 of 1
QL Mainboard mechanical drawing
Posted: Tue Oct 20, 2020 10:42 am
by Peter
Hi,
is there a drawing of the QL mainboard, with mechanical dimensions, outline, connector locations, etc.?
Thanks
Peter
Re: QL Mainboard mechanical drawing
Posted: Tue Oct 20, 2020 10:47 pm
by Derek_Stewart
Hi Peter,
The omly information I have seen is in the QL Service Manual, which does not have any mechanical drawings of the QL PCB, Case, Keyboard mountings.
I guess the there was a design file with this information prior to the launch of the QL, with all the mechanical design information. But I think this will of being lost.
I was going do a Mechanical drawing in Freecad, of the keyboard, to detail the keyboard switch positions. Maybe I could e tend this to other parts of the QL.
Freecad is a parametric 3D modelling software with limited 2D facilities.
Re: QL Mainboard mechanical drawing
Posted: Wed Oct 21, 2020 5:15 am
by Dave
I did this in around 2004. It’s a couple of computers ago, but if the file still exists I’ll find it. It also included variations of positions of internal connectors.
Re: QL Mainboard mechanical drawing
Posted: Wed Oct 21, 2020 3:45 pm
by Peter
Dave wrote:I did this in around 2004. It’s a couple of computers ago, but if the file still exists I’ll find it. It also included variations of positions of internal connectors.
Many thanks Dave, that would be cool!
Re: QL Mainboard mechanical drawing
Posted: Mon Oct 26, 2020 7:01 pm
by Dave
I've been through all the machines in the house and not found it yet. I have two machines in storage that it might be on. I'll dig them out.
Re: QL Mainboard mechanical drawing
Posted: Mon Oct 26, 2020 8:55 pm
by Peter
Thank you Dave, but please no further efforts, that would be more than if I do a little measuring.