Wiring pin out for top lid
Posted: Thu Jun 30, 2016 11:58 am
Because my QL has been acting up, I took the lid off. Luckily, I don't have a normal keyboard, so there was no risk of the membrane cracking up. However the joints on the IDE like cable that links the keyboard to the main board is going to need a resolder.
But now to the point of my post, some Of the wires from the top lid are loose. I don't know how it is on other QLs, but I have a connector behind and to the left of MDV1. The wires are just shoved in to the holes. So I could really do with some sort of pin out for this connector. Such as which pin is the drive light for mdv1, mdv2 etc. I'm planning on soldering some sort of header or at the very least some pins to these wires, so they don't just fall out when the lid is removed.
But now to the point of my post, some Of the wires from the top lid are loose. I don't know how it is on other QLs, but I have a connector behind and to the left of MDV1. The wires are just shoved in to the holes. So I could really do with some sort of pin out for this connector. Such as which pin is the drive light for mdv1, mdv2 etc. I'm planning on soldering some sort of header or at the very least some pins to these wires, so they don't just fall out when the lid is removed.