Ah, OK. Bit of a schlep from London...
I have the equipment needed to reflash the QL-SD device and have made the same change on one of mine successfully.
PM me and perhaps we can figure out how cost effective shipping to/fro would be.
Or are you planning to attend the Dormagen event in May?
QL-SD jumperable
-
Derek_Stewart
- Font of All Knowledge
- Posts: 4021
- Joined: Mon Dec 20, 2010 11:40 am
- Location: Sunny Runcorn, Cheshire, UK
Re: QL-SD jumperable
Hi,
If there is any problems, I can also perform the task.
The QL-SD ROM PCB just need a 3 pin jumper soldered in and I have a an adapter to program the QL-SD firmware without soldering the the pin header to the QL-SD.
If there is any problems, I can also perform the task.
The QL-SD ROM PCB just need a 3 pin jumper soldered in and I have a an adapter to program the QL-SD firmware without soldering the the pin header to the QL-SD.
Regards,
Derek
Derek
Re: QL-SD jumperable
Hi Martyn, Derek.
Great! Thank you so much for the response and the offer. (It's wonderful to be in a cool community like this where people are always willing to help).
I will send you private messages to see the possibilities.
Greetings!
Great! Thank you so much for the response and the offer. (It's wonderful to be in a cool community like this where people are always willing to help).
I will send you private messages to see the possibilities.
Unfortunately, I can't go to Dormagen, it's a pity because it will be a very relevant event in the QL world. (We will all be eagerly awaiting the news and events of the meeting).martyn_hill wrote: ↑Wed May 01, 2024 12:16 am Or are you planning to attend the Dormagen event in May?
Greetings!